The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.
An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.
The air conditioning system can be prone to refrigerant leaks and failure of one or more pressure sensors. The AC pressure sensors should be checked for proper operation when ever the AC system is serviced.
The anti-lock brake (ABS) accumulator may fail causing loss of power brake assist. (The brake pedal will become very hard.)
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed .
The intake manifold gasket may develop external engine oil leak. The manifold gasket will need to be replaced to correct this issue.
The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to cool down before it will restart.
The fuel pump may fail causing the engine to stall and not restart.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
Our technicians recommend to replace the fuel system filter every 30,000 miles.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
A loose or worn gas cap may cause check engine light to illuminate.
A coolant leak may develop from the water pump . This can result in an engine overheating condition. A leaking water pump will require replacement.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The crankshaft position sensor , ignition module , and/or powertrain control module (PCM) may fail resulting in illumination of the Check Engine Light with ignition system related fault codes stored in the PCM. Patience is necessary when dealing with this specific situation as normal diagnostic procedures are not effective. In many cases, the best option is to replace parts, one at a time until the fault is corrected.
related to ignition, no-spark
related to exterior-light, headlight, stay-on
related to exhaust, catalytic-converter
related to body, hood
related to body, window, not-working
related to trouble-codes, p-codes-powertrain, p1600-p1699, p1651
related to fuel-system, fuel-pump, fuse
related to engine-cooling, thermostat, housing
related to fuel-system, fuel-pressure
related to fuel-system, fuel-pump, replace-remove
related to general, noises, click
related to engine-cooling, coolant-flush
related to body, door, symptoms, open
related to general, noises, grind
related to engine-cooling, leak
related to warning-lights, low-coolant-light
related to fuel-system, fuel-pump, replace-remove
related to fuel-system, fuel-pump, relay
related to steering, pump, replace-remove
related to suspension, shock
related to steering, column, loose
related to exterior-light, headlight, fuse
related to body, door, symptoms, close
related to interior, water
related to body, windshield, washer, not-working
related to tires, lug-nut