The mode and temperature door actuators may fail causing improper air flow or temperature output from the heating and AC (HVAC) system.
The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.
Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.
The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.
Do to a low or erratic voltage condition, the fuel gauge needle may "jump" around and become stuck on the back side of the "stop" below the "empty" indicator. This does not mean the gauge is broken. If the gauge cover is removed and the needle is gently moved back around to the correct side of the pin, the gauge will again function normally. When the needle is moved back to the correct position, the electrical problem that caused the needle to jump in the first place must be corrected or the needle may jump around again. The most common problems that cause this condition are a weak battery or corrosion on the battery cable ends.
The intake manifold gasket may develop external engine oil and/or coolant leak. The intake manifold will need to be removed and the gasket replaced to correct this issue.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The fuel pump can fail causing the engine to stall and not restart. Our technicians highly recommend to replace your fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
The water pump may develop a engine coolant leak resulting in an engine overheating condition.
The leak may come from the "weep hole" in the water pump, which is designed to show when the water pump is failing and requires service.
Another source of the leak could be a failed water pump gasket, but in either case, replacement of the water pump will likely be the correction.
Illumination of the check engine light may be the result of a loose or worn gas cap .
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The steering rack may fail causing a loss of power steering fluid as a result the steering may become hard to turn.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.
You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed .
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
related to general, noises, chirp
related to interior, instrument-cluster, replace-remove
related to engine-cooling, cooling-fan, not-working
related to body, window, switch, replace-remove
related to safety, seat-belt
related to interior, instrument-cluster, gauges, fuel-level
related to interior, interior-lights
related to body, window
related to interior, water
related to body, sunroof, not-working
related to exterior-light, headlight, stay-on
related to interior, instrument-cluster, gauges, fuel-level
related to warning-lights, oil-light
related to suspension, sway-bar
related to suspension, sway-bar, link, replace-remove
related to suspension
related to interior, water
related to fuel-system, fuel-injector, replace-remove
related to general, fuse-test
related to general, noises, moan
related to interior, instrument-cluster, gauges, fuel-level
related to body, trunk, water
related to trouble-codes, p-codes-powertrain, p0100-p0199, p0102
related to interior, instrument-cluster, gauges, fuel-level
related to suspension, strut, bolt
related to exterior-light, brake-light, not-working