2012 Mitsubishi Eclipse Spyder OBD2 Code P0121 TPS A Circuit Range Performance Problem

P0121 code definition

Throttle Pedal Position Sensor/Switch (TPS) A Circuit Range Performance Problem

What the P0121 code means

P0121 is a generic OBD-II code which indicates that the Engine Control Module (ECM) has seen the TPS sensor circuit A learned output voltage go above or below the sensor's expected range when compared to TPS sensor circuit B.

What causes the P0121 code?

• The TPS sensor circuit A learned range output to the ECM went above the specified voltage difference between TPS sensor circuit B by more than 1.6 volts

• The TPS sensor circuit A learned range output to the ECM went below the specified voltage difference between TPS sensor circuit B by going less than .8 volts.

What are the symptoms of the P0121 code?

• The ECM turns the Check Engine Light on and goes into a failsafe mode by cutting current to the throttle actuator to put the throttle valve to approximately less than 6 degrees opening.

• The ECM controls fuel injection and timing to control engine speeds

• The 2012 Mitsubishi Eclipse spyder would be able to be driven very slowly with limited throttle response.

• The engine may idle higher than normal and not accelerate as before.

• Note : The symptoms are determined by the manufacturer failsafe ECM strategy for your 2012 Mitsubishi Eclipse spyder during a failure and may vary between manufacturers and 2012 Mitsubishi Eclipse spyders.

How does a mechanic diagnose the P0121 code?

• Scanning and documenting the codes received and viewing the freeze frame data to see when the P0121 code was set.

• Clearing the OBD-II fault codes and retesting your 2012 Mitsubishi Eclipse spyder to see if the P0121 code comes back.

• Visually checks all TPS connections and wiring for any loose or damaged items.

• Comparing the data between TPS circuit A and B on the scanner and if incorrect, performing the TPS pinpoint tests as per the manufacturer's recommendations.

Common mistakes when diagnosing the P0121 code?

Not following these simple steps:

• Not conducting a visual inspection first

• Not scanning, documenting, clearing or retesting for codes to verify failures

• Replacing a TPS sensor before tests indicate a problem

• Not comparing TPS sensor A and B specifications before and after repair or replacements

How serious is the P0121 code?

The P0121 code will cause the engine ECM to go into a failsafe mode, which will cause various drive complaints until repairs are done like lack of acceleration, high idle, bucking or jerking, limited speeds, or stalling, depending on manufacturer failsafe mode strategy.

What repairs can fix the P0121 code?

• Repairing or replacing the TPS connector
• Repairing the wiring as necessary
• Replace the TPS with a new sensor

Additional comments for consideration regarding the P0121 code

• The P0121 code may be accompanied by other TPS codes, so other repairs may need to be followed up with in order to have a complete fix.

• Most failures for code P0121 are for a defective TPS sensor not tracking the throttle angle correctly.

• All TPS codes will cause the ECM to go into failsafe mode.

• The drive symptoms of all TPS codes will be roughly the same.

Need help with a P0121 code?

Check Engine Light

P0121

trouble codes