One or more of the power window regulators (one in each door) may fail causing the window to fall into the door and not roll up .
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The engine may develop oil leaks from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
The torque converter clutch (TTC) may stop working due to an internal transmission failure. The Check Engine Light will illuminate if this occurs. Our technicians tell us the transmission will require dis-assembly to correct this concern.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The crankshaft position sensor may fail causing the engine to stall intermittently, the Check Engine Light may or may not illuminate.
The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.
The electronic level ride system may not work properly; this may result in the rear of the vehicle riding too high or too low. Our technicians tell us that a height sensor or exhaust valve failure are common issues with this system. Proper diagnoses will be necessary to confirm the exact fault.
Overheating of the engine may cause the cylinder head to expand, severely straining the head bolts and damaging the threads in the engine block. This commonly results in a blown head gasket . Our technicians tell us the engine block threads must be repaired before the cylinder head is reinstalled.
The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.
One or more of the power window regulators (one in each door) may fail causing the window to fall into the door and not roll up .
An ignition coil may fail causing one of the cylinders to misfire . Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.
The EGR valve may stick open, causing a rough idle and/or the check engine light to illuminate.
The water pump and/or the plastic side tanks on the radiator may leak causing a loss of coolant . The engine may overheat due to coolant loss. Continued coolant loss after external leaks have been repaired could indicate a blown head gasket .
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
Failure of the catalytic converter can result in illumination of the Check Engine Light .
The high-pressure power steering lines are known to leak.
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.
This powertrain control module (PCM) may develop a fault with its electrical ground location at the front of the engine block near the starter motor.
Illumination of the check engine light may be the result of a loose or worn gas cap .
related to suspension, symptoms, vibration
related to exterior-light, reverse-light
related to steering, symptoms, leak
related to exhaust, loud
related to fuel-system, gas-cap
related to steering, hose, replace-remove
related to body, door, lock, replace-remove
related to suspension, shock, estimate
related to suspension, symptoms, low
related to ignition, spark-plug, replace-remove
related to general, shakes
related to safety, airbag, switch, replace-remove
related to safety, airbag
related to safety, airbag, computer
related to safety, seat-belt
related to safety, airbag, sensor, location
related to warning-lights, check-engine-light
related to steering
related to interior, instrument-cluster, gauges, speedometer, not-working
related to warning-lights, airbag-light
related to warning-lights, check-engine-light