2006 Mazda 6 Common Problems, Issues, Recalls, and Reliability

  • 2006 Mazda 6 Engine Overheating Due to Failed Cooling Fan Control Module

    The engine may overheat due to erratic engine cooling fan operation as a result of a faulty cooling fan control module. Replacement of the fan control module would be necessary to correct this condition. Our technicians tell us the Mazda may provide assistance with the cost of this repair.

  • 2006 Mazda 6 Updating PCM Software Will Help Problem With Stalling Under Light Acceleration

    Some models may have a problem with stalling under light acceleration. Updated software for the powertrain control module (PCM) is available which may help with this concern.

  • 2006 Mazda 6 Shifting Concerns for the Six Speed Automatic Transmission

    A well-documented and well-known issue with the Mazda 6 built between 2005-2012 is harsh shifting from the 6-speed automatic transmission , and slight slippage between gears. This has been noted as hesitation to accelerate, especially from a stop.

    Mainly, software issues have been to blame for these mishaps, but mechanical malfunctions related to shift solenoids and the valve body have also been major causes. Finally, the automatic transmissions in these models are sold as ‘sealed for life’, yet the transmission fluid does not seem to last the complete service life of the vehicle.

    Correction of these issues often requires a simple software update, meaning the vehicle only needs to be plugged in, and the transmission controller receives new programming meant to fix these drivability concerns. In cases where this does not correct concerns, the transmission must be removed, inspected, and repaired, possibly requiring a complete rebuild.

    To mitigate these issues from escalating to a full transmission rebuild, many technicians recommend replacing the transmission fluid at regular intervals, yet the manufacturer has never offered this guidance.

  • 2006 Mazda 6 Ticking Noise From Valve Lash Adjusters Due to Infrequent Oil Changes

    A loud ticking noise (hydraulic valve lifter noise) may be heard from the top of the engine, particularly when the engine is still cold. The noise may occur more frequently on higher mileage vehicles; Hydraulic valve lash adjusters may need to be replaced to correct this issue. Following the maintenance schedule for oil changes will also help prevent a recurrence of the noise.

  • 2006 Mazda 6 Emissions recall due to problem with swirl shutter valve

    Mazda issued an emissions recall due to a problem with the Swirl Shutter Valve; this would cause the Check Engine light to illuminate.

  • 2006 Mazda 6 Check Engine Light Due to Faulty Intake Manifold Runner Control Valve

    The Check Engine Light may illuminate with a stored code P2006. This is most often caused by a sticking intake manifold runner control (IMRC) valve. Our technicians tell us that depending on your vehicle the valve may require replacement and/or the powertrain control module (PCM) software will require upgrading.

  • 2006 Mazda 6 Lack of power caused by oversensitive knock sensor

    A lack of power may be caused by an oversensitive knock sensor . Our technicians tell us reprogramming the powertrain control module (PCM) software may correct this issue.

2006 Mazda 6 Questions and Answers

Related Questions

  • Mazda 6 2006 Mazda 6 Clicking Noise

    2006 MAZDA 6, 6 CYL, FWD, AUTOMATIC, 55, 000 MILES

    related to general, noises, click

    What is causing a clicking noise from my left front tire when I turn left? Sounds like a loud "baseball card in a spoke" of a bike. Sometimes pronounced, sometimes almost not there. Howexpens..

  • Mazda 6 Open Door From Inside Or Outside

    2006 MAZDA 6

    related to body, door, symptoms, open

    Hi, My dad has a Mazda 6 and recently the driver's door locked itself. It now won't open from the inside or the outside. All the other doors are fine. They will open, close and lock. He took t..

  • Mazda 6 2006 Mazda 6 Flex Pipe

    2006 MAZDA 6, 98, 500 MILES

    related to exhaust, flex-pipe

    I recently noticed that my car was getting a little loud. I brought it in to have it looked at and they told me that it my flex pipe had a hole in it and would need to be replaced. The part is curre..

  • Mazda 6 Headlights

    2006 MAZDA 6

    related to exterior-light, headlight, replace

    Change front headlight mazda 6 @media(max-width: 960px) { .adt { display: none;padding:0; } } Wednesday, December 1st, 2010 AT 2:22 PM ..

  • Mazda 6 O2 Sensor But There Is No Dash Light On

    2006 MAZDA 6, 115, 115 MILES

    related to interior, dashboard, light

    Hi 2carpros in the past you have been very helpful to me. Now my daughter has a problem with her 2006 Mazda a 6, with a 2.3 size engine and the automatic transmission is doing a hard down shift whe..

  • Mazda 6 Do I Have A Major Electrical Problem Or Is It...

    2006 MAZDA 6, 102, 000 MILES

    related to body, door, lock, not-working

    Hello All. I bought a 2006 Mazda 6 (3.0L, 6 CYL). Apparently the windshield wasn't sealed properly and water leaked into the car near the fuse box. Afterwards, several electrical components in ..

  • Mazda 6 Alternator Light?

    2006 MAZDA 6, 6 CYL, FWD, AUTOMATIC

    related to warning-lights, battery-light

    My check engine light went on, and now its also stuck in 3rd gear, coincidence? @media(max-width: 960px) { .adt { display: none;padding:0; } } Sunday, January 30th, 2011 AT 1:36 PM ..

  • Mazda 6 Where Is Turn Signal Flasher Located?

    2006 MAZDA 6, 114, 000 MILES

    related to exterior-light, turn-signal, flasher

    I have no turn signals or hazard lights. I want to change the flasher but I cant find it @media(max-width: 960px) { .adt { display: none;padding:0; } } Saturday, April 7th, 2012 AT 11:..

  • Mazda 6 CEL CODE P2097, P2177 And P2187

    2006 MAZDA 6, 87, 000 MILES

    related to warning-lights, check-engine-light

    Hi, I'm having a problem right now with my Mazda 6i 2.3 2006. Three CEL code went on this week P2097, P2177 and P2187. It all started when I changed my air filter. I took it for a ride af..

  • Mazda 6 Electric Door Lock Problem

    2006 MAZDA 6, 2.3L, 4 CYL, MANUAL, 135, 000 MILES

    related to body, door, lock, not-working

    The door locks have stopped working as well as intermediate working of the parking and turn signals. What could be causing this? @media(max-width: 960px) { .adt { display: none;padding:0; } } ..

  • Mazda 6 Fuel Pump Removal

    2006 MAZDA 6, 2.3L, 4 CYL, 2WD, AUTOMATIC, 149, 000 MILES

    related to fuel-system, fuel-pump, replace-remove

    I'm trying to replace the fuel pump in my car, but when it comes to pulling it out it seems it's a hair or two too big. I saw people replace them without taking the fuel tank off, but I'm leading ..

  • Mazda 6 Hazard Lights Coming On When I Use Signal

    2006 MAZDA 6, V6, 2WD, MANUAL, 156 MILES

    related to exterior-light, hazard-light

    Why does my hazard lights turn on when I put my turn signal on? Does it Have a flash relay if so where is it? @media(max-width: 960px) { .adt { display: none;padding:0; } } Friday, ..

  • Mazda 6 Lots Is Issues Mazda

    2006 MAZDA 6, 3.0L, 6 CYL, AUTOMATIC, 259, 000 MILES

    related to exterior-light, hazard-light, flasher

    Hello in have a mazda 6 2006 v6 3.0L. 6 days a go the car was working fine I came home turned off the car and the next morning I came to the car I saw the hazard lights are on and the car is off I w..

  • Mazda 6 2006 Mazda 6 Coolant Temp Sensor

    2006 MAZDA 6, 6 CYL, FWD, MANUAL, 89, 000 MILES

    related to engine-cooling, coolant-temperature-sensor

    If coolant temp sensor wasn't plugged up in my car would I have any syptoms before it over heated @media(max-width: 960px) { .adt { display: none;padding:0; } } Wednesday, October 27th..

  • Mazda 6 2006 Mazda 6 Engine Light

    2006 MAZDA 6, 6 CYL, 2WD, AUTOMATIC, 40, 000 MILES

    related to warning-lights, check-engine-light

    Engine light has come on. I checked the gas cap and oil. Car runs good. No noises @media(max-width: 960px) { .adt { display: none;padding:0; } } Monday, November 9th, 2009 AT 7:54 PM ..

  • Mazda 6 2006 Mazda 6 Engine Light Is On

    2006 MAZDA 6, 6 CYL, FWD, AUTOMATIC, 38, 000 MILES

    related to warning-lights, check-engine-light

    Yeah my engine light is on. i was just curious is there is a common occurence to why it comes on, it has been on constant for a little while now. can it be an expensive fix or no can i..

  • Mazda 6 Front And Rear Jack Points

    2006 MAZDA 6

    related to general, tools, jack

    Four cylinder front wheel drive automatic 22,000 miles. Can anyone tell me how to find the front and rear jack points on my car? The owners manual just shows me the jack points on the side of ..

  • Mazda 6 2006 Mazda 6 Jacking And Tire Rotation

    2006 MAZDA 6, 4 CYL, FWD, AUTOMATIC, 22, 000 MILES

    related to general, tools, jack

    Is it safe to jack up one whole side of your car and place on jack stands in order to rotate tires. Basically place the driver side, front and back on jack stands. @media(max-width: 960px) { ...

  • Mazda 6 2006 Mazda 6 Making A Clicking Sound When...

    2006 MAZDA 6, 6 CYL, FWD, AUTOMATIC, 50, 106 MILES

    related to general, noises, click

    It started about a week ago I barely noticed it. But now I notice it all the time. What it is is after ive been driving around for a bit and for instance stop at a stop sign, when I start accelera..

  • Mazda 6 2006 Mazda 6 Steering

    2006 MAZDA 6, 4 CYL, FWD, AUTOMATIC, 40, 000 MILES

    related to steering, steering-wheel

    When steering wheel is turned fully to either side to make a u turn the steering wheel does not recover. The steering wheel has to straightened by hand for the car to drive straight. Also with car p..

  • Mazda 6 2006 Mazda 6 Window Frost

    2006 MAZDA 6, 4 CYL, FWD, AUTOMATIC, 74, 000 MILES

    related to body, window

    While running the a/c in my mazda 6, air blows out of the defrost vent and frost up the lower area of the front winshield. It doesn't matter if the recirculate of fresh air is on. Please help. ..

  • Mazda 6 Rodent Chewed Up Bunch Of Wires Now ABS Lights On

    2006 MAZDA 6, 2.3L, 4 CYL, 2WD, AUTOMATIC, 142, 000 MILES

    related to warning-lights, abs-light

    A rodent made a nest and chewed up wires to my transmission speed sensor and knock sensor which gave me a bunch of error codes/lights on my dash. Mechanic fixed knock sensor and transmission spee..

  • Mazda 6 Thermostat Code

    2006 MAZDA 6, 2.4L, 4 CYL, 2WD, AUTOMATIC, 102, 500 MILES

    related to engine-cooling, thermostat, replace-remove

    I recently had my OEM sensor replaced and now my thermostat is giving a code. Are these issues related? @media(max-width: 960px) { .adt { display: none;padding:0; } } Friday, May 1st, ..

2006 Mazda 6 Maintenance and Repair