2006 Ford GT OBD2 Code P0120 TPS A Circuit Malfunction

P0120 code definition

Throttle Pedal Position Sensor/Switch (TPS) "A" Circuit Malfunction

What the P0120 code means

P0120 is the generic OBD-II code which indicates that the Engine Control Module (ECM) has seen the TPS sensor circuit A output voltage going below or above the sensor's expected range, or is chattering when compared to TPS sensor circuit B.

What causes the P0120 code?

• The ECM detected that the output from TPS sensor circuit A went outside of the specified voltage range in relation to TPS sensor circuit B.

• The TPS sensor circuit A output falls below .2 volts or goes above 4.5 volts.

What are the symptoms of the P0120 code?

• The ECM turns on the Check Engine Light and goes into failsafe mode by cutting the current to the throttle actuator to put the throttle valve at approximately less than 6 degrees opening.

• The ECM controls fuel injection and timing to control engine speeds.

• The 2006 Ford GT would be able to be driven very slowly with limited throttle response.

• The engine may idle higher than normal, but will not accelerate properly.

Note : The symptoms are determined by the manufacturer failsafe ECM strategy for your 2006 Ford GT during a failure and may vary between manufacturers and 2006 Ford GT s.

How does a mechanic diagnose the P0120 code?

• Scans and documents the codes received and views the freeze frame data to see when the code was set

• Resets the codes to clear the OBD-II fault codes and retests your 2006 Ford GT to see if the code comes back

• Visually checks all of the TPS connections and wiring for any loose or damaged items.

• Compares the data between TPS circuit A and B with a scanner, and if incorrect, replaces the TPS as directed by the pinpoint testing.

Common mistakes when diagnosing the P0120 code

• Not performing a visual inspection first

• Not scanning, documenting, clearing, and retesting for codes to verify failures

• Not replacing an TPS sensor when tests indicate a problem

• Not comparing TPS sensor A and B to be within specification before and after repair or replacements

How serious is the P0120 code?

The P0120 code will put the engine ECM to go into a failsafe mode, which will cause various drive complaints until repairs are done. For example, lack of acceleration, high idle, bucking or jerking, limited speeds, and possible stalling depending on the manufacturer failsafe mode strategy.

What repairs can fix the P0120 code?

• Repairing or replacing the TPS connector
• Repairing the wiring as necessary
• Replacing the TPS with a new sensor

Additional comments for consideration regarding the P0120 code

• The P0120 code may be accompanied by other TPS codes, so following the manufacturer pinpoint tests for each code received may be needed to fix the complaint.

• Most failures for code P0120 involve a defective TPS sensor not tracking the throttle angle correctly.

• All TPS related codes will enable the failsafe mode and cause the same drive symptoms.

Need help with a P0120 code?