The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to cool down before it will restart.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
The Engine Control Module (ECM) can fail causing stalling, and engine and transmission drivability concerns.
The water pump may develop a coolant leak resulting in an engine overheating condition.
The fuel pump may fail causing engine to stall and not restart.
The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.
You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed .
Contaminated brake fluid can cause problems in the brake system and it should be flushed every 60,000 miles.
Air flow from the dash vents may be incorrect due to a damaged engine vacuum hose near the battery tray.
The upper intake manifold gasket and/or a PCV vacuum lines/hoses can develop vacuum leaks with age. This type of leak can result in a higher that normal or rough idle .
The intake manifold gasket can develop external engine oil leaks. The intake manifold will need to be removed and the gaskets replaced to correct this issue.
Fuel injectors can short-circuit electrically causing a rougher than normal idle and reduced performance.
The cam sensor interrupter (magnet) may become demagnetized and/or fall off of the camshaft gear causing the Check Engine Light (Service Engine Soon) light to illuminate. On higher mileage vehicles it would be advisable to replace the timing chain and gears if this problem were to occur as the timing cover must be removed to replace the interrupter.
related to ignition, coil, replace-remove
related to ignition, module
related to trouble-codes, obd1-codes, code-26
related to trouble-codes, obd1-codes, code-26
related to ignition, spark-plug, replace-remove
related to exterior-light, brake-light, fuse
related to trouble-codes, obd1-codes, code-41
related to exterior-light, turn-signal, not-working
related to ignition, spark-plug, replace-remove
related to trouble-codes, obd1-codes, code-41
related to suspension, strut, replace-remove
related to fuel-system, fuel-pump, fuse
related to interior, instrument-cluster, gauges, odometer, not-working
related to ignition, no-spark
related to fuel-system, fuel-pump, replace-remove