It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
Illumination of the check engine light may be the result of a loose or worn gas cap .
The intake manifold gasket can develop external engine oil leaks. The intake manifold will need to be removed and the gaskets replaced to correct this issue.
The upper intake manifold may develop an internal coolant leak causing one or more cylinders to fill with coolant. This can cause the engine to "hydro-lock" and not turn over. Removing the spark plugs will allow the engine to turn over pushing the coolant out of the spark plug holes. Replacing the upper intake plenum and gasket is commonly required to correct this condition.
The engine can be very difficult to start after this problem has been repaired, it can be helpful to clear as much of the coolant from the intake manifold and cylinders as possible before reassembling the intake manifold.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The water pump may develop a coolant leak resulting in an engine overheating condition.
The fuel pump can fail causing the engine to stall and not restart. Our technicians highly recommend to replace your fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
The anti-lock brake (ABS) pressure modulator valve assembly may fail internally causing the ABS light to illuminate.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
The steering rack may fail causing a loss of power steering fluid as a result the steering may become hard to turn.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.
You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed .
related to engine-cooling, leak
related to ignition, no-spark
related to ignition, coil, replace-remove
related to interior, interior-lights
related to general, noises, squeak
related to body, wiper, speed
related to interior, dashboard, light
related to steering