If the engine cranks but does not start, it may be caused by a tripped inertia switch. Switch the key to "ON" and the fuel pump should be heard running for a second or two. Listen at the gas filler if necessary. If you do not hear the pump the inertia switch should be reset, it will "click" when it is reset.
If the engine cranks but will not start, it may be due a failed distributor . In the diagnosis, it may be discovered that the Electronic Engine Control (EEC) Unit is the cause if ignition spark is restored after disconnecting the Spark Output (SPOUT) Connector.
Misfires under load (acceleration) can be caused by leaky spark plug boots. When a spark plug boot leaks, it allows the spark to arc, or jump, to the cylinder head . If evidence of arcing can be seen on the inside of the spark plug boot, new spark plug wires will be needed.
Vehicles with a V6 engine may develop an engine misfire under load (acceleration). This can be caused by a valve cover gasket leaking oil into a spark plug well, shorting the spark plug to the cylinder head . To repair this concern, the valve cover needs to be resealed and the spark plugs and wires should be replaced.
The "Bypass Air Control Valve" can fail causing a low engine idle and possibly stalling.
A knocking sound heard from the front or rear suspension while driving over rough roads may be caused by the sway bar linkages. The linkages should be inspected for tightness and condition; there are redesigned linkages if replacement is necessary.
related to body, door, latch
related to safety, airbag, sensor
related to security, disarm
related to ignition, distributor, rotor
related to ignition, spark-plug, replace-remove
related to general, fuse-test
related to exterior-light, headlight, not-working
related to ignition, no-spark
related to engine-cooling, radiator, replace-remove
related to security, disarm
related to warning-lights, low-fuel-light
related to body, trunk, open