The Acura MDX may develop issues with the automatic transmission .
Rough shifting may occur, and the “D4” light and check engine may begin to blink. The check engine light will also illuminate, and OBD trouble codes P0700 , P0730 , P0740 , P0780 , P1768 and/or P1768 will be stored in the computer.
If the transmission shifts roughly, the failure is very likely mechanical failure of the transmission. If the transmission performs normally, a faulty sensor, or dirty transmission fluid may be the case.
In most cases, it is necessary to use professional diagnostic equipment to provide a diagnosis, and complete the repair.
The longevity of the transmission is dependent on strict adherence to the manufacturer's recommendation for ATF replacement intervals and procedure.
The clutch in the torque converter can fail, allowing debris to circulate throughout the automatic transmission.
The exhaust recirculation valve ( EGR ) on the 2002-2017 Acura MDX may fail, causing:
The EGR valve has open and closed positions, and opens or closes on command from the computer.
Exhaust gases constantly pass through the valve when it is open, leaving carbon deposits on the valve. These carbon deposits may lead the the valve sticking in the open or closed position.
To correct this issue, sometimes it is sufficient to clean the valve, but replacement is recommended in all cases.
For further information on your vehicle's issue, try out our diagnostics tool here .
The Acura MDX may have issues with the idle air control system, causing:
The idle air bypass system is made up of vacuum lines, an idle air control valve (IACV), the throttle body, and intake manifold, and allows enough air into the engine to idle when the throttle body is closed. The OBD trouble code P0505 refers you to this system to inspect for failures.
The most likely cause is a dirty or failed IACV, but vacuum lines, intake manifold gasket, throttle body gasket, and IACV gasket should be inspected.
In all cases involving the IACV, the throttle body ports should be cleaned prior to installing the IACV onto the throttle body.
The 2002-2017 Acura MDX may have problems with the EVAP canister vent solenoid . It stops responding to commands to open and close, and the following occurs:
The valve is located on the charcoal canister , and is meant to open and close upon command. It fails due to corrosion breaking one of two internal seals, which allows air to escape the system, signaling the OBD trouble code P1457.
Correcting the problem can be done by replacing the vent valve, or, in some cases, cleaning and resealing the vent valve has been successful. You can get an estimate for this repair here .
A worn, missing, or loose gas cap can cause the same issues.
A shudder or vibration may develop while driving at speeds between 35 and 40 MPH. Our technicians tell us this condition is commonly caused by a failed automatic transmission torque converter . It is recommend to replace the torque converter and install an updated powertrain control module (PCM) to correct this concern.
To review some comments from the RepairPal community regarding this issue, please click here>>
Acura issued a recall on a number of 2005 vehicles because the gas tanks were improperly manufactured and could leak in the event of a crash. It is unclear if all the fuel fill issues are related to the recall or not. For more information on this recall please click here»
related to body, wiper, rear
related to exhaust, catalytic-converter, estimate
related to interior, navigation
related to steering, hose
related to body, wiper, rear
related to steering, tie-rod-end
related to interior, navigation, not-working
related to general, used-car-advice