Error Code P1495 is defined as VAP Leak Detection Pump Solenoid Circuit Condition. This code pertains to a fault in the Leak Detection Pump.
This error code is a manufacturer-specific trouble code, meaning it does not apply to all cars makes. Rather, it applies only to specific 2019 Ford Ranger makes, such as Chrysler, Dodge, and Jeep. Specification on the definition, troubleshooting, and repairs still vary from one make and model to another.
The EVAP (Evaporative Emission System) is designed to prevent fuel vapors from escaping the fuel system. Leaks in this part of your 2019 Ford Ranger will allow fuel vapors to escape into the atmosphere. It is the job of the Leak Detection System test to look for EVAP system blockages and leaks.
Error Code P1495 refers to a problem in your 2019 Ford Ranger ’s leak detection pump, which is part of the emission system. This code is detected when the PCM (powertrain control module, also known as ECM or engine control module in other 2019 Ford Ranger makes) determines that the solenoid did not change status when activated. Most often than not, this code appears when there is a bad leak detection pump.
As with other error codes, this code activates the Check Engine light and registers to your 2019 Ford Ranger ’s system. One of the most noticeable symptoms is fuel odor caused by the release of fuel vapors.
There are a couple of factors that cause this error code, some of the common causes are:
Other possible causes for this error include:
The first thing you need to check for this error code is the electrical wires; check for broken or loose electrical wirings.
Then, check the vacuum lines for signs of tears or disconnects. If this all checks, then there’s a good chance the fault is caused by a defective Leak Detection Pump (LDP). This pump is located under your 2019 Ford Ranger , towards the left side.
Repairs for this code are pretty simple, but of course, require a thorough diagnosis.
Repair or replace broken or loose electrical wirings
Repair or replace tears or disconnects in vacuum lines
Replace LDP
Most of the time, replacing the LDP can fix this error code.