Damaged wiring to the seat belt pre-tensioner sensor may cause the Airbag Warning Light to illuminate.
A vibration felt at 55 mph may not be a tire problem. Mazda has revised motor mounts available which may help remedy this problem.
A loose rear stabilizer bar link can cause a rattling noise from the rear suspension while driving on rough roads. Our technicians tell us if the rear stabilizer bar and links are not found to be loose, there are updated sway bar bushings available which should correct this problem.
The rear brakes can squeak because the rear brake pad may be contacting the brake rotor . A burr on the backing plate of the brake pad can prevent the pad from seating in the bracket properly causing the contact with the rotor. The backing plate and the pad support hardware can be deburred in the contact areas. Mazda has also released revised brake pads.
Excessive engine vibration or knocking noises heard while the engine is idling, being started or switched off are usually caused by a defective engine mount at the top right side of the engine. A redesigned engine mount is available to alleviate this problem.
Internal failure of the ignition switch may create a condition where the key reminder continues to chime even though the key is removed. In addition, the doors cannot be locked with the keyless entry system. Replacing the ignition switch with an updated switch is the typical repair.
If the steering effort feels heavy, this can be caused by a power steering fluid leak. Some models may have burrs on the return port of the power steering reservoir that create a gap between the hose and the port. Sanding the burrs off the port and replacing the power steering return hose is the repair for this concern.
Some vehicles may experience Check Engine Light illumination with a trouble code indicating the thermostat is stuck open. The thermostat will need to be replaced with a modified one and there is a software update for the Powertrain Control Module (PCM).
The engine may be difficult to start in extremely cold weather (-20F) after a short trip. This can be caused by sticking main relay points.
A low speed stall when the throttle pedal is slightly pressed and released may mean the Engine Control Module (ECM) needs to be reflashed (updated).
related to steering, symptoms, hard
related to security, fuse
related to suspension, strut, replace-remove
related to trouble-codes, p-codes-powertrain
related to steering, symptoms, hard
related to exhaust, white-smoke-
related to warning-lights, check-engine-light
related to body, window, not-working
related to warning-lights, check-engine-light
related to body, door, symptoms, open
related to general, noises, rattle
related to suspension, shock, replace-remove
related to general, noises, squeal
related to engine-cooling, cooling-fan, not-working
related to steering, pump
related to interior, instrument-cluster, gauges, engine-temperature
related to warning-lights, check-engine-light