Bogging, hesitation or stalling may be experienced during moderate to heavy acceleration. This can be caused by a failing of many sensors or modules in the fuel injection system. It is recommended to have an experienced shop perform diagnosis to find the root of the problem.
The engine may have a higher that normal idle at times. After cold start with an automatic transmission and when the clutch is depressed with a manual transmission. Our technicians tell us updated powertrain control module (PCM) software is available to address this concern.
The Ford Ranger V6 is known for a rough idle, engine stalling, loss of power, and misfires, accompanied by the check engine light .
The intake manifold O-ring gaskets commonly leak, which creates a large vacuum leak. This vacuum leak causes unmetered air to enter the engine, and the fuel system becomes insufficient to compensate for the large amount of air reaching the engine.
Replacing the intake manifold gaskets corrects this concern.
Many customers state that whule driving their vehicle, the engine will hesitate, stumble, or lose power. In more severe cases, the EGR valve can be physically damaged. In all cases, the check engine light will be illuminated, and diagnostic trouble codes will be stored in the PCM.
Diagnosis of the issue has concluded the differential pressure feedback EGR sensor (DPFE) is at fault many times, and incorrectly measures exhaust gas re-circulation (EGR) pressure.
Correction of the issue requires a diagnostic scan, identification of the faulty sensor, and, ultimately, the sensor and EGR valve may require replacement. In some models, the DPFE sensor is integrated into the EGR valve, and must be replaced together.
The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.
Moisture inside the rear brake drum assemblies can cause the rear drum brakes to grab, or lock when first driving. Inspect the rear brakes, replace the rear shoes as needed, and make any adjustments. The back side of the backing plate needs to be sealed where moisture can get into the drums to prevent this from recurring.
A buzzing type noise may be noted from upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.
Noisy engagement of clutch slave cylinder to the pressure plate can cause a squeak noise when pressing and releasing the clutch . Replacement of the clutch disc, pressure plate, clutch slave cylinder, plus the application of a special metal assembly paste to the mating components will be needed to reduce the noise.
related to engine-cooling, coolant-temperature-sensor, location