A door window may move slowly or stop in mid travel due to a failing power window motor . The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
A coolant leak may develop from the water pump . This can result in an engine overheating condition. A leaking water pump will require replacement.
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians often recommend replacement of the front rotors and brake pads as the best option to correct this condition.
The automatic transmission shifter may fail causing the ignition key to become stuck in the ignition lock cylinder .
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
The instrument panel and switch backlighting may fail due to a faulty dimmer control module. A failed module will require replacement.
A weak battery or a burned out brake light bulb may cause the ABS light to illuminate.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
The ignition switch may fail causing a no start condition. This is not generally a theft system ( passlock ) issue because the security light does not illuminate or flash.
A loose or worn gas cap may cause check engine light to illuminate.
An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.
The Engine Control Module (ECM) can fail causing stalling, and engine and transmission drivability concerns.
related to body, door, lock, not-working
related to security
related to trouble-codes, p-codes-powertrain, p0400-p0499, p0405
related to ignition, spark-plug, replace-remove
related to engine-cooling, thermostat, location
related to warning-lights, check-engine-light
related to general, noises, clunk
related to body, door, panel
related to engine-cooling, leak
related to steering, symptoms, noise
related to exterior-light, headlight, switch, replace-remove
related to fuel-system, fuel-leak
related to engine-cooling, thermostat, location
related to interior, water