The automatic transmission may fail prematurely. Transmission overhaul or replacement may be necessary to correct this concern.
The crankshaft position sensor may fail causing a stalling can/or no start condition. Replacing the faulty crankshaft position sensor should correct this condition.
A hard or no start condition with fault codes P0335 and/or P0340 stored in the powertrain control module (PCM) may be due to abnormal wear of the camshaft position sensor support. Our technicians tell us a revised sensor support is available to correct this issue.
It is not uncommon for the clear coat paint to develop white spots and begin peeling. In most cases Mitsubishi will not cover out of warranty repairs for this condition.
An engine overheating condition may develop due to a failed radiator cooling fan controller. The failed controller should be replaced to correct this issue.
Erratic HVAC blower motor operation may be caused by a failed blower motor and/or blower motor resistor . Our technicians tell us that if the blower motor resistor fails the blower motor should be checked. If the blower motor fails its functional test in should be replaced along with the failed blower motor resistor.
Erratic HVAC blower motor operation may be caused by a failed blower motor and/or blower motor resistor . Our technicians tell us that if the blower motor resistor fails the blower motor should be checked. If the blower motor fails its functional test in should be replaced along with the failed blower motor resistor.
related to general, noises, tick
related to general, used-car-advice
related to fuel-system, fuel-leak
related to steering, symptoms, pull
related to engine-cooling, coolant-flush