Erratic turn signal operation can be a result of a failing turn signal flasher relay which will require replacement.
Vacuum leaks, oxygen sensor failure, and catalytic converter efficiency faults can cause the Check Engine Light to illuminate.
Engine oil leaks are common from the valve cover gaskets and camshaft chain tensioner gasket.
A creaking type noise may be noted from the front suspension. Replacement of the front sway bar may be required to correct this issue.
An ignition coil or spark plug may fail unexpectedly resulting in an engine misfire and possible illumination of the Check Engine Light .
Popping sounds from the rear of the vehicle may be heard moments after starting the engine, or when slowing to a stop. This noise is from the leak detection pump filling the fuel tank with air, and releasing to retest the system when it finds a fault. The sequence of faults identifying this issue are as follows:
The cause is a valve which is mounted on the front of the intake manifold, commonly called the N80 valve, or EVAP system purge valve. The valve is designed to open under specific circumstances, but a worn valve will remain open at all times, preventing the pressurization of the fuel tank.
Correction of the issue is to replace the N80 valve with the latest revision.
The water pump may fail resulting in engine overheating and possible timing belt damage. Overheating and/or timing belt failure can result in very expensive engine repairs. As a precaution, it is recommended to inspect the timing belt and water pump at regular intervals.
To avoid sludge accumulation inside the engine, our technicians recommend using the proper synthetic oil with the appropriate oil filter .
related to warning-lights, airbag-light
related to exterior-light, turn-signal, not-working