Damaged wiring to the seat belt pre-tensioner sensor may cause the Airbag Warning Light to illuminate.
A vibration felt at 55 mph may not be a tire problem. Mazda has revised motor mounts available which may help remedy this problem.
A loose rear stabilizer bar link can cause a rattling noise from the rear suspension while driving on rough roads. Our technicians tell us if the rear stabilizer bar and links are not found to be loose, there are updated sway bar bushings available which should correct this problem.
The rear brakes can squeak because the rear brake pad may be contacting the brake rotor . A burr on the backing plate of the brake pad can prevent the pad from seating in the bracket properly causing the contact with the rotor. The backing plate and the pad support hardware can be deburred in the contact areas. Mazda has also released revised brake pads.
Excessive engine vibration or knocking noises heard while the engine is idling, being started or switched off are usually caused by a defective engine mount at the top right side of the engine. A redesigned engine mount is available to alleviate this problem.
Internal failure of the ignition switch may create a condition where the key reminder continues to chime even though the key is removed. In addition, the doors cannot be locked with the keyless entry system. Replacing the ignition switch with an updated switch is the typical repair.
related to engine-cooling, cooling-fan, stays-on
related to exhaust, white-smoke-
related to tires, rim