The mode and temperature door actuators may fail causing improper air flow or temperature output from the heating and AC (HVAC) system.
The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.
Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.
The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.
Do to a low or erratic voltage condition, the fuel gauge needle may "jump" around and become stuck on the back side of the "stop" below the "empty" indicator. This does not mean the gauge is broken. If the gauge cover is removed and the needle is gently moved back around to the correct side of the pin, the gauge will again function normally. When the needle is moved back to the correct position, the electrical problem that caused the needle to jump in the first place must be corrected or the needle may jump around again. The most common problems that cause this condition are a weak battery or corrosion on the battery cable ends.
The intake manifold gasket may develop external engine oil and/or coolant leak. The intake manifold will need to be removed and the gasket replaced to correct this issue.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The fuel pump can fail causing the engine to stall and not restart. Our technicians highly recommend to replace your fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
The water pump may develop a engine coolant leak resulting in an engine overheating condition.
The leak may come from the "weep hole" in the water pump, which is designed to show when the water pump is failing and requires service.
Another source of the leak could be a failed water pump gasket, but in either case, replacement of the water pump will likely be the correction.
Illumination of the check engine light may be the result of a loose or worn gas cap .
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The steering rack may fail causing a loss of power steering fluid as a result the steering may become hard to turn.
The ABS brake pressure modulator valve can fail internally causing the ABS light to illuminate.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
The Engine Control Module (ECM) can fail causing stalling and various other engine & transmission drivability concerns.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.
You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed .
A door window may move slowly or stop in mid travel due to a failing power window motor . The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
related to exterior-light, brake-light
related to exterior-light, running-light
related to general, fuse-test
related to exterior-light, turn-signal
related to exterior-light, brake-light
related to suspension, symptoms, noise
related to fuel-system, fuel-filter, location
related to general, fuse-test
related to steering, steering-wheel, replace-remove
related to exterior-light, brake-light, switch, replace-remove
related to body, window, switch
related to interior, radio, not-working
related to fuel-system, fuel-pump, relay
related to ignition, spark-plug, replace-remove
related to warning-lights, check-engine-light
related to interior, instrument-cluster, gauges, engine-temperature
related to suspension, shock, replace-remove
related to tires, symptoms, loose
related to general, noises, whirring
related to exterior-light, running-light, stay-on
related to interior, dashboard, light
related to general, noises, roaring
related to exterior-light, running-light, not-working