Damaged wiring to the seat belt pre-tensioner sensor may cause the Airbag Warning Light to illuminate.
A vibration felt at 55 mph may not be a tire problem. Mazda has revised motor mounts available which may help remedy this problem.
A loose rear stabilizer bar link can cause a rattling noise from the rear suspension while driving on rough roads. Our technicians tell us if the rear stabilizer bar and links are not found to be loose, there are updated sway bar bushings available which should correct this problem.
The rear brakes can squeak because the rear brake pad may be contacting the brake rotor . A burr on the backing plate of the brake pad can prevent the pad from seating in the bracket properly causing the contact with the rotor. The backing plate and the pad support hardware can be deburred in the contact areas. Mazda has also released revised brake pads.
Internal failure of the ignition switch may create a condition where the key reminder continues to chime even though the key is removed. In addition, the doors cannot be locked with the keyless entry system. Replacing the ignition switch with an updated switch is the typical repair.
Mazda issued an emissions recall due to a problem with the Swirl Shutter Valve; this would cause the Check Engine light to illuminate.
If you hear a constant grinding noise from the front brakes, even when not pressing the brake pedal, it is possible the wheel hub has shifted in the steering knuckle causing the brake rotor to grind against the caliper bracket. The hub will need to be inspected (replaced if necessary) and Mazda has a repair procedure for this concern.
If the steering effort feels heavy, this can be caused by a power steering fluid leak. Some models may have burrs on the return port of the power steering reservoir that create a gap between the hose and the port. Sanding the burrs off the port and replacing the power steering return hose is the repair for this concern.
Some vehicles may experience Check Engine Light illumination with a trouble code indicating the thermostat is stuck open. The thermostat will need to be replaced with a modified one and there is a software update for the Powertrain Control Module (PCM).
The engine may be difficult to start in extremely cold weather (-20F) after a short trip. This can be caused by sticking main relay points.
Some vehicles may make a single clicking noise when changing gear direction. This can be caused by a "stick-slip" condition between the CV axle shaft and wheel hub . Mazda has washers that can be installed between the axle shaft and wheel hub that addresses this concern.
A bolt may break on motor mount #4 causing excess engine movement. In extreme cases the movement of the engine may cause the driveshaft to disengage from the transmission. Mazda has issued a recall for this concern, #07V29500.
related to ignition, spark-plug, replace-remove
related to general, noises, clunk
related to engine-cooling, leak
related to general, used-car-advice
related to tires, symptoms, flat
related to suspension, symptoms, bounce
related to tires, symptoms, noise
related to safety, airbag, replace-remove
related to suspension, ball-joint, replace-remove
related to exterior-light, headlight, lens
related to fuel-system, fuel-filter
related to trouble-codes, p-codes-powertrain
related to tires, symptoms, flat
related to safety, seat-belt, replace-remove
related to fuel-system, tank
related to steering, steering-wheel, replace-remove