It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
A loose or worn gas cap may cause check engine light to illuminate.
Illumination of the check engine light may be the result of a loose or worn gas cap .
The service steering column lock message may be displayed, the engine may start and stall when put into gear. Our technicians tell us that this fault is related to the anti-theft system and the steering column lock system must be repaired as necessary. Certain models were recalled for this issue. For more information on this recall please click here»
A coolant leak may develop from the water pump . The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light . It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
A coolant leak may develop from the water pump . This can result in an engine overheating condition. A leaking water pump will require replacement.
Brake fluid can become dirty and may cause problems in the brake system ; it should be flushed every 60,000 miles.
Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light . It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order. If the fluid is dark in color, the transmission should be flushed.
Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order. If the fluid is dark in color, the transmission should be flushed.
The removable roof panel may separate from its frame while driving requiring replacement of the roof panel.
A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.
A loose or worn gas cap could be cause the check engine light to illuminate.
related to exterior-light, turn-signal, switch
related to fuel-system, fuel-pump, fuel-pressure